Cursor position
Posted: Fri Dec 17, 2021 3:47 pm
Hi Les,
This would be a good help if possible?
I use mouse/cursor postion a lot to get co ords for lining up sheet remnants, it's easy to see part position as it is, but I tend to get mixed up between X & Y with the cursor
Something like that would be a big help
This would be a good help if possible?
I use mouse/cursor postion a lot to get co ords for lining up sheet remnants, it's easy to see part position as it is, but I tend to get mixed up between X & Y with the cursor
Something like that would be a big help