sheetcam.com

Posted: **Sat May 30, 2015 7:19 pm**

Im having issues with pocketing when i set the cut to 0 or 90 deg to get straight cuts for the final finish, so the machine marks a parallel or vertical, around complex pictures i always seem to get 1 or 2 lines where (set to 0 deg angle) the step ain't X>>>>>>Y DOWN X<<<<<<<<<Y Down
when changing between y cut height it steps on an angle. seems to be on only small areas with X movement. is there any way i can change that so it is always 100% thane angle i choose? hop that makes sense, as with the bottom left of the attached picture you will see what i mean.

Posted: **Mon Jun 01, 2015 5:06 pm**

If SheetCam thinks it is quicker to simply move from the end of one part of the pocket to the start of another part of the pocket rather than lifting the cutter it will do so. I have added an option for the next development version so you can force it to always lift for moves.

Posted: **Mon Jun 01, 2015 8:38 pm**

Thanks les is that far away!

Posted: **Tue Jun 02, 2015 2:17 pm**

Hopefully I'l have a new release out in a couple of weeks.

Posted: **Fri Jul 03, 2015 4:47 am**

any progress on this Les.

Posted: **Sun Sep 06, 2015 8:22 am**

Les has there been any progress on this update?

Posted: **Tue Sep 08, 2015 3:39 pm**

It has been in the development version for a little while. Look for 'Always lift cutter when repositioning'

Posted: **Mon Dec 21, 2015 5:17 am**

Has this option disappeared? I remember using it now can't seem to find it again?

sheetcam.com

zigzag pocket 0-90 deg

zigzag pocket 0-90 deg