Loading configuration via network
Posted: Tue Dec 23, 2014 7:14 pm
I have Sheetcam installed on two computers (one in my office and one in the shop) that are networked together.
The issue I run into is anytime I make any changes to the configuration (tools, table layout, etc.) on one computer, I have to duplicate it on the other so they give the same results.
I was wondering if it is possible to load the Sheetcam configuration via a network drive rather than the local hard drive.
Basically, the Sheetcam software would be installed on each computer separately. However, when it loads the configuration files it would pull this information from a common location. Thereby keeping both installations in-sync.
The issue I run into is anytime I make any changes to the configuration (tools, table layout, etc.) on one computer, I have to duplicate it on the other so they give the same results.
I was wondering if it is possible to load the Sheetcam configuration via a network drive rather than the local hard drive.
Basically, the Sheetcam software would be installed on each computer separately. However, when it loads the configuration files it would pull this information from a common location. Thereby keeping both installations in-sync.