TNG V0.0.16 Milling problem

ArchieF · Post by **ArchieF** » Mon Apr 28, 2008 4:14 pm

Hi Les,

in V0.0.16 the contour-process does only the 'outside-offset' - method correct. The 'no offset' - method creates the same code as the 'inside-offset' - method.
That means there is no 'no-offset' possible.

Please take a look.

Thank you

Richard

Post by **Les Newell** » Tue Apr 29, 2008 4:56 pm

Hi Richard,

It has been fixed in the latest release. Sorry about that.

Les

ArchieF wrote:

Hi Les,

in V0.0.16 the contour-process does only the 'outside-offset' - method correct. The 'no offset' - method creates the same code as the 'inside-offset' - method.
That means there is no 'no-offset' possible.

Please take a look.

Thank you

Richard

Post by **Les Newell** » Tue May 06, 2008 1:57 pm

Hi Richard,

It has been fixed in the latest release. Sorry about that.

Les

ArchieF wrote:

Hi Les,

in V0.0.16 the contour-process does only the 'outside-offset' - method correct. The 'no offset' - method creates the same code as the 'inside-offset' - method.
That means there is no 'no-offset' possible.

Please take a look.

Thank you

Richard

-------------------- m2f --------------------

Reply to this post simply by hitting reply in your email client or you can read this topic online here:
http://www.forum.sheetcam.com/viewtopic.php?p=8509#8509

-------------------- m2f --------------------