Hi,
maybe it's me, maybe it's a bug: (version 7.1.35 linux, registered)
1) I added a G4 P10 (wait 10 seconds - for linuxCNC QTPlasmaC) before my usual code tool for Center Spot in the relative center_spot code snippet.
2) I Checked the T99 (my center spot tool) to verify that "Use Led In Settings" was checked and that the "Use Code Snippet" contains the "center_spot" code.
3) I saved the default tools
4) I reopened the job file (previously done with old center spot code) containig the job I need to modify (various nested parts)
5) I reloaded the default tools
6) I deleted the first center spot (drill) operation
7) I re-did the drill center spot operation (to the correct layer)
I run post processor
=> The G4 P10 is not added to the Gcode.
I tried this many times and tried closing and reopening the software, deleted gcode file, resaved job file... no way.
I think the old snipped code remains somewhere... or... I don't know.
I checked the snippet code, it's ok, it contains the G4 P10...
Is it a Bug?
Is there a way to update all my center spot operations (even re-doing the operations)...
at the moment I will edit manually, it's a simple modify but...
Thanks, Alberto
Maybe a Bug: Can't update operation new code snippet
-
- Posts: 6
- Joined: Thu Apr 28, 2022 6:14 am
- Les Newell
- Site Admin
- Posts: 3685
- Joined: Thu May 11, 2006 8:12 pm
Re: Maybe a Bug: Can't update operation new code snippet
Could you send me an example job file demonstrating the issue.
-
- Posts: 6
- Joined: Thu Apr 28, 2022 6:14 am
Re: Maybe a Bug: Can't update operation new code snippet
Yes of course
- Attachments
-
- PROT_004_6mm_catenanaccio_ALL.job
- (39.45 KiB) Downloaded 29 times
-
- Posts: 6
- Joined: Thu Apr 28, 2022 6:14 am
Re: Maybe a Bug: Can't update operation new code snippet
And here the toolset if needed,
thanks.
(..and "Keep parts together" was selected in "Job options").
thanks.
(..and "Keep parts together" was selected in "Job options").
- Attachments
-
- sheetcam_toolset.tools.zip
- (938 Bytes) Downloaded 31 times
-
- Posts: 6
- Joined: Thu Apr 28, 2022 6:14 am
Re: Maybe a Bug: Can't update operation new code snippet
Solved: it was in the postprocessor.
The postprocessor has a "drill part" in which the drill code.... So I don't know if the "snipped center_spot" code is needed anymore, but... ok, I modified the postprocessor and now it works.
The postprocessor has a "drill part" in which the drill code.... So I don't know if the "snipped center_spot" code is needed anymore, but... ok, I modified the postprocessor and now it works.