Les is it possible to do a J shaped leadin on holes?
Eg. pierce at the hole centre, then move to the start of the arc leadin shown in the pic. then carry on as normal
This would leave the pile of dross on a pierce as far from the cut as possible but provide a nice leadin more like the Hypertherm true hole technology.
I want to combine it with an overcut which can be done in Plasmac without the postprocessor getting involved.
J Leadin For holes
-
- Posts: 257
- Joined: Thu Feb 26, 2015 12:11 am
Re: J Leadin For holes
why not just use the centre pierce function for holes?
I think it's in operation
I think it's in operation
Re: J Leadin For holes
No I want to cut holes where I can and I want to pierce in the middle but retain an arc leadin which I can't see is possible. This is to implement some advanced hole cutting that not currently supported out of the box.robertspark wrote: ↑Mon May 24, 2021 5:27 pm why not just use the centre pierce function for holes?
I think it's in operation
I do spot and drill some holes on a separate layer at other times.
Re: J Leadin For holes
Well that strange
How was that hole lead in done?
Found here viewtopic.php?f=2&t=8415&start=30#p28081
How was that hole lead in done?
Found here viewtopic.php?f=2&t=8415&start=30#p28081
Re: J Leadin For holes
OK, can forget this now. Amazing what an upgrade does now it lets me
Worked it out
Worked it out