-------- Original message --------
From: "'Les Newell' yahoo@forum.sheetcam.com [sheetcam]"
Date:01/07/2015 5:38 PM (GMT-06:00)
To: features@forum.sheetcam.com
Subject: [sheetcam] Re: Switch Offset not posting
This does sound like a post problem. I have to admit I don't have a copy of rev 11d.
I'm not sure if Tom wants this post made publicly available so could you email it to me or PM me with a copy and a sample job file.
You can single step posts. Open the post editor then click in the left hand darker grey margin to set a breakpoint. Leave the editor open and run the post. There are buttons for single step, continue etc on the top toolbar in the editor. There is a window on the bottom of the editor that shows any current errors and the stack (all variables and the function call stack). If you can't see the bottom window, you should be able to enlarge it by dragging it's sash upwards.
__._,_.___
Posted by: jeepsr4ever <jeepsr4ever@yahoo.com>
Visit Your Group
Unsubscribe ([email]sheetcam-unsubscribe@yahoogroups.com?subject=Unsubscribe[/email]) • Terms of Use
__,_._,___