I have an inch based NC drill file for a PCB.
With a standard import into Sheetcam the scale box is greyed out but showing 25.4
The file imported correctly.
Problem is the PCB I have produced is a tiny bit undersized so I want to scale the import of the drill file to match.
Tried a custom scale number but the measurement from hole to hole did not change. Tried a much bigger difference in the scale number (20:1) and still no change in the imported file.
Any ideas.
Cheers,
Keith.
Scaling not working with NC drill file
-
- Posts: 162
- Joined: Tue Feb 25, 2014 6:53 am