Plasma torch height after the cut has finished (set height)
Posted: Fri Apr 19, 2024 4:14 am
Good day.
Trying to figure this out.
On my router after the cut has finished it goes to x0, y0 and z0.8"
I want to replicate this on the plamsa...I tried parking settings and it will go to x0 and y0 but the torch raises all the way up.
parking z will be bypassed in the Mach safe z setting if I am not mistaken.
Is there a way to set this?
Thank you!
Trying to figure this out.
On my router after the cut has finished it goes to x0, y0 and z0.8"
I want to replicate this on the plamsa...I tried parking settings and it will go to x0 and y0 but the torch raises all the way up.
parking z will be bypassed in the Mach safe z setting if I am not mistaken.
Is there a way to set this?
Thank you!