hi all,
its been a while since i have used my plasma table and i noticed today that the gcode that is generated from sheetcam does not seem to be telling my swiftcut swifty1250 to turn the THC on.
in the Gcode, it is only telling the machine to turn the THC off, but never telling it to turn on in the first place. as a result the THC isnt doing anything and i have had a few torch crashes today.
with the original software from swiftcut it does tell the THC to turn on, the problem is only when i use sheetcam.
am i being daft and missing something obvious that is stopping the gcode from generating the THC on command?
thanks in advance