Hello Everyone
I bought sheetcam in 2004 or 2005. After a 10 year break from cnc I tried to get back into it in 2016 Les was kind enough to look up my license key and sent a new copy to me. Now 7 years later I have finally gotten a new cnc partially built and am starting to practice with freecad and trying to get sheetcam to generate the g-code for drilling hold-down holes for my table it only generates 2 lines of code G21 M5 M30. After reading a post about the same issue here on the forum I re did the license key but it still outputs the same code. Its a long time since I have done any cad work or sheetcam use so it might be my newbie attempts to use it.
Thanks for any help James Coleman
Warning feed rate is zero
- Les Newell
- Site Admin
- Posts: 3680
- Joined: Thu May 11, 2006 8:12 pm
Re: Warning feed rate is zero
If your license is that old it was probably for the original SheetCam. This license won't work with SheetCam TNG.